Learning CS and Math with Robotics
Piano MinView
 Grid Lines: Tics Lines: Width px Hash Lines: Width px Labels: Font px Trace Lines: Robot 1: Width px Robot 2: Width px Robot 3: Width px Robot 4: Width px
 Simple View: Grid Size: S M L
 Coord: x-axis y-axis Grid Lines: x-axis y-axis Grid: 12x12 inches 24x24 inches 36x36 inches 72x72 inches 96x96 inches 192x192 inches 1x1 inches 2x2 inches Fraction: 2 3 4 5 6 7 8 9 10 11 12 Quad: 1 Quadrant 4 Quadrants 1&4 Quadrants Units: US Customary Metric Ruler:

#### Robot 1

0
S
M
L
 Initial Position: ( in, in) Initial Angle: deg Current Position: (0 in, 0 in) Current Angle: 90 deg Wheel Radius: 1.75 in1.625 in2.0 in

#### Robot 2

0
S
M
L
 Initial Position: ( in, in) Initial Angle: deg Current Position: (0 in, 6 in) Current Angle: 0 deg Wheel Radius: 1.75 in1.625 in2.0 in

#### Robot 3

0
S
M
L
 Initial Position: ( in, in) Initial Angle: deg Current Position: (0 in, 12 in) Current Angle: 0 deg Wheel Radius: 1.75 in1.625 in2.0 in

#### Robot 4

0
S
M
L
 Initial Position: ( in, in) Initial Angle: deg Current Position: (0 in, 18 in) Current Angle: 0 deg Wheel Radius: 1.75 in1.625 in2.0 in
Graphing Linear Equations: Horizontal and Vertical Lines
Graphing Linear Equations: Horizontal and Vertical Lines
 The pre-placed block plots a point on the coordinate grid. Use drivexyTo( ) blocks to move the robot and trace a vertical line and horizontal line that both go through the point. The vertical line should start from y = -12 and go to y = 24, and the horizontal line should start at x = -12 and end at x = 24. Remember to turn trace OFF when moving between points where you do not want to trace a line on the grid.
 Load Blocks Symbol Symbol+Word Word Hardware LArduino Workspace Show Ch Save File Console

Time